September 1 2009
by Elizabeth Meister

Create Brushed Finish on Sterling Silver

The third is very similar to the satin finish , however you will use more aggressive means to obtain your new look. To create the brushed look, the finish will have more distinctive lines. You can use many things to create look. By hand you could use, and emery board or a file. Or you can use a course steel wool pad, a ball of aluminum foil or any other course metal or abrasive material.

With all of the above methods, I suggest either working at your bench, where you can clean up any metal shavings that may come off your piece. Otherwise working on a table with some newspaper down to catch the shavings is perfect. Take each piece you'd like to brush, and be sure to brush all sides, if it tends to slide, feel free to put a small amount of tape on your surface, in a loop, so it will stick to the surface and to the other side of your piece and stay still the entire time you're brushing your component.

Be careful with gold vermeille, as gold vermielle is sterling silver that is been plated with 14kt gold, so be wary of putting any aggressive finishing techniques as the gold may come off.

When creating your own brushed finish, it can be used in many different ways. If you're looking for a more defined look than satin, but not as rough as a hard brush with an emery board. You can complete a piece in full, and then run it through a steel wool pad, or a 3M pad. This will give it slight more edge than your regular satin finish. Or you can brush each individual piece and then put them all together. But, be sure to think of the small things, which will really bring the whole design together. Pieces that are often forgotten are components like jump rings , the clasp or the bail . These are parts that, if brushed, will complete the look. And remember, mix it up, and have fun with it!