June 9 2009
by C.S.

There are three standard jewellery pins; head pins, ball pins, and eye pins. And then, there are always unique jewellery pins that provide a cap with in the in pin itself. Stones and Findings a wide variety of pins, including ball pins , eye pins , head pins as well as fancy pins in sterling silver, gold filled and gold vermeille.

However there are times when all you need in your design is just the bead. If your design requires nothing fancy on the end of your pin, then there is a great way to create your own pin head. This works especially well with pearls. Often basic pins are a little too thick for your standard drill hole on a pearl, too. The examples below demonstrate how you can make the different types of pins, using Sterling Silver Wire. You can however, just as easily use Gold Vermeille or Gold Filled wire.

Head Pin

Simply take a section of your sterling silver 22 Gauge wire, and cut off the desired length for your pin. Then put this section of sterling silver wire, into your parallel pliers, leaving a millimeter peeking out at the end. With a flat nose hammer, hammer the exposed bit of your sterling silver wire with a few strikes. Hammer in one direction, and then take out the pin and rotate it a quarter of the way. Then continue to strike the sterling silver tip. This will expand the metal just enough to stop your bead from sliding off the end of the wire. By rotating your piece ofsterling silver wire, you will ensure that the end of the pin is equally fanned out. And there you have it; you've created your own sterling silver head pin.

Now to the naked eye, it may not seem like you've created something that will stop the pearl, but by creating a small flat end on your sterling silver wireyou will essentially stop it from sliding off.

*TIP* - to get a professional finish, use an old pair of parallel pliers, or wrap masking tape around your pliers ends to ensure that you do not leave any hammer marks on your sterling silverpins.